Fujitsu PRIMERGY RX1330 M1 User Manual

RX1330 M1 Operating Manual 51
Hardware installation
5.3 Connecting devices to the server
The connectors for external devices are on the front and rear of the server. The
additional connectors available on your server depend on the expansion cards
installed.
I Some of the devices that can be connected may require special
software, e.g. drivers (see the documentation for the connected device).
Figure 2: Ports on the front
The following connectors are located on the front of the server:
A front VGA connector is available as an option
10 HDD variant
For the variant with 10 HDDs of the PRIMERGY RX1330 M1 there is an
USB 2.0 connector on the front panel on QRL instead of above mentioned
USB3.0 connectors.
1 2 x USB 3.0 connectors
햲

Fujitsu PRIMERGY RX1330 M1 Specifications

General

Number of Processors	1
Memory Slots	4
Maximum Memory	32 GB
Form Factor	1U Rack
Processor	Intel Core i3 product family Intel Pentium product family
CPU Family	Intel Xeon
Memory Type	DDR3 UDIMM
Storage	Up to 4 x 3.5" or 2.5" drives
Drive Bays	4
RAID	0, 1, 5, 10
RAID Controller	Optional
Network	2 x Gigabit Ethernet
Operating System Support	Windows Server, Red Hat Linux, SUSE Linux