1
3
Installing internal options
If internal options have been purchased separately, install them before installing the operating system.
In the following case, it is not required to install the internal options.
- Custom Made Service
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, contact an ofce listed
in the "Contact Information".
n
PRIMERGY RX200 S3 Manuals
Manuals for this server can be accessed from the section below of the PRIMERGY Document & Tool CD.
[CD-ROM Drive] :\MANUAL\INDEX.PDF
Manuals can be displayed using Acrobat
®
Reader
®
or Adobe
®
Reader
®
. If using Acrobat
®
Reader
®
, use version 5.0 or later.
2
Reading and understand-
ing "Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
Also check it when connecting, installing internal options
and setting up this server.
n
Point to note before installing internal
options
When installing internal options, perform operations after
reading the following manuals.
"Chapter 7 Installing Internal Options"
"PRIMERGY Server Books"/"Supplement"
Install the OS before installing the following options.
Installing the OS after options have been installed will
cause installation operations to end in an error.
- Non-system hard disks
- External SCSI optional devices (Hard disk cabinet,
Backup cabinet, DAT unit , etc.)
n
Available Internal options and
installation locations
To Next Page
Need help?
General
