Fujitsu PRIMERGY RX2520 M1 - Indicators on the Control Panel

66 Operating Manual RX2520 M1
Starting up and operation
6.1.3.2 Indicators on the control panel
NMI NMI button
V CAUTION!
Do not press! Risk of loss of data! The NMI button may only
be used by service personnel.
RST Reset button
Pressing the reset button reboots the system.
V CAUTION!
Risk of loss of data!
ID ID button
Lights up (blue) on the front and on the rear of the server when the
ID button is pressed. Both ID indicators are synchronized.
Power-on indicator (green)
Lights up green when the server is switched ON.
Flashes green, when the server is in sleep mode.
Remains dark when the server is switched OFF, but mains voltage
is present (standby mode). After connecting the server to the mains
it takes about 60 seconds until the server enters the standby mode.