For the latest information on optional products provided for the
RX4770 M2 see the configurator of the server:
http://ts.fujitsu.com/products/standard_servers/index.html
(for the EMEA market)
http://jp.fujitsu.com/platform/server/primergy/system/
(for the Japanese market)
System board
The features of the system board are described in the "FUJITSU Server
PRIMERGY RX4770 M2 Upgrade and Maintenance Manual", the setup
possibilities are described in the "D3349 BIOS Setup Utility for FUJITSU Server
PRIMERGY RX4770 M2 Reference Manual".
Hard disk drives
The server can be equipped with up to 8 HDD/SSD modules and 4x PCIe SSD.
Each HDD/SSD module can accommodate an HDD/SSD drive with a 2.5-inch
format. The modules are connected to the SAS/SATA backplane wirelessly.
This allows HDD/SSD modules to be plugged in or pulled out easily.
The hard disk system is designed for SAS/SATA with one channel for each hard
disk drive.
If the server has the corresponding RAID configuration, the HDD/SSD modules
can also be replaced during operation.
SAS/SATA controller card (optionally with RAID controller)
The SAS/SATA controller card for operating up to eight SAS/SATA hard disk
drives can be alternately without or with RAID functionality. In case of RAID
functionality the levels 0, 1, 1E, 5, 6, 10, 50 and 60 are supported.
Flash Backup Units
Up to two Flash Backup Units (FBUs) back up the memory contents of their
corresponding RAID controllers in the event of power failure (option).
Accessible drives / components
A number of mounting locations are available:
– An installation slot for a ServerView Local Service Display (standard)
– An installation slot for a slimline DVD/BD drive (option)
To Next Page
Loading...
Need help?
General