5.4.2 Connecting the power cord
Ê Connect the power cord to the server power supply unit.
Ê Secure the power cords in the cable clamps so the insulated connectors
cannot be disconnected from the server accidentally.
Figure 6: Cable clamps to secure the power cords
Ê Thread the cable through the cable clamp as shown in figure 6 on page 59.
Ê Pull the cable clamp tight to secure the power cord.
Now the insulated connector cannot be disconnected from the server
accidentally.
I You can loosen the cable clamp by opening the small locking lever.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network or a power outlet of the socket strip in the rack (see Technical
Manual for the rack).
To Next Page
Loading...
