Fujitsu Primergy TX120 Start Guide

6
l
PRIMERGY information
The latest PRIMERGY, driver, and software information is
available at the address below.
http://primergy.fujitsu.com
l
Before requesting repairs
If an error occurs in this server, refer to "User's Guide
9.2 Troubleshooting". If problems can still not be solved,
contact an ofce listed in the "Contact Information".
When contacting the ofce listed in the "Contact Informa-
tion", inform them of the product ID and manufactures
number that are detailed on labels at the upper-right corner
of the server.

       


 



Also read the points to note about requesting repairs be-
forehand in "User's Guide 9.8.1 Contacting Maintenance
Support".
Print the "Conguration Sheets"- "Accident sheet" that
is available from Fujitsu PRIMERGY website (http://
primergy.fujitsu.com) and enter the conrmed information.
Send this sheet and the stored BIOS setting information to
your maintenance engineer.
9
Hints for error handling
In preparation for a failure, set the following:
"Chapter 5 Operations after OS Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is auto-
matically saved when the STOP error occurs in the system.
This helps to analyze the cause of errors.
- Create a system restoration disk
When the system le or system environments are dam-
aged, the system can be reconstructed with the content
saved in the system restoration disk.
- Store system settings
By storing the BIOS setting information, the original in-
formation can be recovered with the stored informaion
in case of that the setting information is lost. The stored
information is also used for the system maintenance.
When the settings are completed, make sure to
check notes before operation.
"5.5 Notes before Operating the Server"
For details about maintenance after operations have
started, refer to "User's Guide Chapter 9 Operation
and Maintenance".
8
Turning off the power and installing optional devices
Install optional devices, such as an UPS device, to be installed after the OS installation.
"Chapter 7 Installing Hardware Options"
1
Check that no medium is inserted in
the CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is automatically
turned off. When the server is not turned off after
the OS is exited, press the power switch on the front
of the server.
3
Turn off the power supply of the periph-
eral devices, such as the display.
This operation is not required when operating from
the management PC by connecting to the Remote
Management Controller port.
4
Install the optional devices.
-
After optional devices are installed, set the BIOS
Setup Utility as required.For details about setting
procedures, refer to the "User's Guide Chapter 8
Conguring Hardware and Utilities".
- If an UPS device is installed, set the BIOS Setup
Utility as required. For details, refer to the "User’s
Guide 5.5.3 Notes on Advanced Uninterruptible
Power Supply (UPS)".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, error will occur that may be cause damage.
10
Support and Service

Fujitsu Primergy TX120 Specifications

General

Brand	Fujitsu
Model	Primergy TX120
Category	Server
Language	English