TX1310 M3 Operating Manual 55
Starting up and operation
I If the operating system does not switch off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
V CAUTION!
There is a risk that data may be lost.
Other Power On/Off options
I The usage of Power On/Off options requires the installation of
ServerView Agents.
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager, you can configure that the
server is switched on/off controlled by timer.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
TM
)
(LAN1 only).
– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS).
– Power button override
The system can be switched off by pressing and holding down the On/Off
button (for approximately 4 - 5 seconds).
V CAUTION!
There is a risk that data may be lost.
To Next Page
Loading...
