54 Operating Manual TX1310 M3
Starting up and operation
Switching the server on
Figure 9: On/Off button of the server
– Starting up for the first time:
For Japan, please refer to " はじめにお読みください ".
Ê Press the On/Off button (1) (see figure 9 on page 54).
Ê Insert the ServerView Suite DVD in the DVD drive.
Ê Follow the on-screen instructions (see also section "Configuring the
server and installing the operating system with the ServerView
Installation Manager" on page 57 or section "Configuring the server and
installing the operating system without the ServerView Installation
Manager" on page 58).
– System already installed:
Ê Press the On/Off button (1) (see figure 9 on page 54).
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode.
To Next Page
Loading...
