Fujitsu ScanPartner SP25

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
92
How to Load
Documents
Scanner
Overview
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Troubleshooting
Device Errors
The following are lists of device errors which require troubleshooting by a service engineer.
■ Flatbed motor malfunction, optical error, and internal error
Check
indicator
Power
indicator
Item Resolution
Flashes
2 times
Turns on Optical error (ADF Front) 1 Clean the glass section.
For details, refer to "Chapter 5 Daily Care" (page 70).
2 Turn the scanner off then back on.
If the problem persists, write down the status of the indicators and contact your
FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
Flashes
3 times
Turns on Optical error (ADF Back)
Flashes
4 times
Turns on Flatbed motor malfunction
(ScanPartner SP30F)
1 Confirm that the transport lock switch is not locked.
2 Turn the scanner off then back on.
If the problem persists, write down the status of the indicators and contact your
FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
Flashes
7 times
Turns on Optical error (Flatbed)
(ScanPartner SP30F)
Flashes
5 times
Turns on Operator panel error Turn the scanner off then back on.
If the problem persists, write down the status of the indicators and contact your
FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
Flashes
6 times
Turns on EEPROM error
Flashes
7 times
Flashes
7 times
Memory error