Function
Function
number
Setting number Default Details
*1 Auto
restart
40
00 Enable
Enable or disable automatic system restart after a power outage.
01 Disable
Cool Air
Prevention
43
00 Super low
Restrain the cold airflow with making the airflow lower when starting
heating operation. To correspond to the ventilation, set to 01.
01
Follow the setting
on the remote
controller
External
control
46
00 Start/Stop
Allow an external controller to start or stop the system, or to perform
an emergency stop, or to perform a forced stop.
* If an emergency stop is performed from an external controller, same
refrigerant system will be disabled.
* If forced stop is set,indoor unit stops by the input to the external input
terminals,and Start/Stop by a remote controller is restricted.
01 Emergency stop
02 Forced stop
Error
report
target
47
00 All
Change the target for reporting errors. Errors can either be reported in
all locations, or only on the wired remote.
01
Display only on
central remote
control
Fan setting
when cooling
thermostat OFF
49
00
Follow the setting
on the remote
controller
When set 00, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
changed Fan mode forcibly.
When set 01, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
stop forcibly.
Connection of the wired remote controller
(2-wire type or 3-wire type) and switching its
thermistor are necessary.
01 Stop
*1 : Auto restart is an emergency function such as for power failure etc.
Do not start and stop the indoor unit by this function in normal operation.
Be sure to operate by the control unit, converter or external input device.
FUNCTION
SETTING
FUNCTION
SETTING
01-20
To Next Page
Loading...
Need help?
General
