Fujitsu UTY-RNRT - Zone Individual Operation; Set the Sensor Method; Set the Priority Sensor; Zone Group Operation

2-3-2 Zone Individual Operation
(1) Touch the [Zone Operation] on
the “Zone Select” screen.
[ ]
Zone Select
Zone
Operation
Sensor
Method
Priority
Sensor
Zone Group Operation
Group3
Back
(2) “Zone Operation” screen is
displayed. Touch the zone to
toggle its outlet opening and
closing.
Cancel OK
Zone7
Zone1
Zone4
Zone8
Zone5
Zone2
Zone6
Zone3
Zone Operation
The outlet of the zone with a check mark opens.
NOTES
• Zones that can be confi gured for outlet opening
and closing are displayed.
• When all zone outlets close, the following screen is
displayed.
Close
Zone Operation
Setting not perfomed. Always perform one setting.
(3) Touch the [OK] on the “Zone Operation” screen to
submit the data to the zone interface, and return to the
”Zone Select” screen.
2-3-3 Set the Sensor Method
(1) Touch the [Sensor Method] on
the “Zone Select” screen.
[ ]
Zone Select
Zone
Operation
Sensor
Method
Priority
Sensor
Zone Group Operation
Group3
Back
(2) “Sensor Method” screen is
displayed. Touch the [Primary
Sensor Control] or [Average
Temperature Control].
Sensor Method
Cancel OK
Primary Sensor Control
Average Temprature Control
(3) Touch the [OK] on the “Sensor Method” screen to
submit the data to the zone interface, and return to the
”Zone Select” screen.
2-3-4 Set the Priority Sensor
(1) Touch the [Priority Sensor] on
the “Zone Select” screen.
[ ]
Zone Select
Zone
Operation
Sensor
Method
Priority
Sensor
Zone Group Operation
Group3
Back
(2) The “Priority Sensor” screen is
displayed. This screen con-
tains up to 4 pages. Touch the
[Next Page] or [Previous Page]
to navigate pages. Touch the
sensor to confi gure.
Priority Sensor
Page 1/ 4
Cancel OK
Next
Page
Sensor3
Sensor2
Sensor1
(3) Touch [OK] to submit the data to the zone interface, and
return to the “Zone Select” screen.
2-3-5 Zone Group Operation
Zones registered to a group can be operated in bulk.
(1) Touch the [Zone Group Op-
eration] on the “Zone Select”
screen.
[ ]
Zone Select
Zone
Operation
Sensor
Method
Priority
Sensor
Zone Group Operation
Group3
Back
(2) The “Zone Group Operation”
screen is displayed. This
screen contains up to 2 pages.
Touch the [Next Page] or [Pre-
vious Page] to navigate pages.
Touch the group to operate,
and touch the [Enable].
Zone Group Operation
Page 1/ 2
Cancel OK
Next
Page
All Zone
Night
Day
Zone List
-
Zone1
-
Zone8
-
Zone2
-
Zone3
-
Zone4
-
Zone7
-
Sensor3
-
Zone5
-
Zone6
Enable
Sensor
(3) Touch the [OK] on the “Zone Group Operation” screen
to submit the data to the zone interface, and return to
the “Zone Select” screen.
En-8
9373329831-02OMEnUTY-RNRT.indd89373329831-02OMEnUTY-RNRT.indd8 2021/11/1913:23:022021/11/1913:23:02