Fujitsu UTY-RVRU - Advanced Energy Saving Modes; Auto Saving, Auto Off, and Auto On;Off Settings

4-3-2-1 Auto Saving
When the absence continues for the set time, the operation
switches to energy saving operation.
If no one enters the room during the set time (15, 30, 60, 90,
120, 180 minutes), the set temperature will be automatically
controlled.
(When someone comes back into the room, the human sen-
sor will detect this, and automatically revert to the original
settings.)
NOTE
For details of Auto Saving, refer to the operation manual
of the indoor unit.
(a)
(b)
(a) Toggle button
Tap to toggle enable/disable.
Enable
Disable
(b) Set time menu
Tap the “Absence Detection Time” and set the time.
(1) Swipe up or down to
select the detection
time and tap it.
(2) Tap [
] to return to
the previous screen.
4-3-2-2 AutoO󰀨
When the absence continues for the set time, indoor unit
operation stops.
If no one enters the room during the set time (1 to 24 hours in
1 hour increments), the air conditioner will automatically stop
operation.
(a)
(b)
(a) Toggle button
Tap to toggle enable/disable.
Enable
Disable
(b) Set time menu
Tap the “Absence Detection Time” and set the time.
(1) Swipe up or down to
select the detection
time and tap it.
(2) Tap [
] to return to
the previous screen.
4-3-2-3 AutoOn/O󰀨
When the absence continues for the set time, indoor unit
operation stops, and resumes operation when a person is
detected.
If no one enters the room during the set time (15, 30, 60, 90,
120, 180 minutes), the air conditioner will automatically stop
operation.
(When someone comes back into the room, the human sen-
sor will detect this, and automatically revert to the original
settings.)
(a)
(b)
(a) Toggle button
Tap to toggle enable/disable.
Enable
Disable
(b) Set time menu
Tap the “Absence Detection Time” and set the time.
(1) Swipe up or down to
select the detection
time and tap it.
(2) Tap [
] to return to
the previous screen.
En-15