Fujitsu UTY-RVRU - Display and Temperature Limit Settings; Display Item Customization and Deadband Setting; Temperature Limit Configuration

5-2-3 Display Item
NOTE
Some items may not be displayed depending on the
model of the indoor unit or the settings of the controller.
(a) (b)
(c)
(a) Backward button
Tap to return to the previous screen.
(b) Home button
Tap to move to the temperature setting screen (home
screen).
(c) Toggle button
Enable the items to be displayed on the screen.
Enable
Disable
5-2-4 Deadband
Set the deadband value. The deadband can be set within the
2ºF to 9ºF (1ºC to 4.5ºC) range. Set the deadband value only
totheMasterIndoorUnit.(Settingsarenotreectedevenif
the deadband value is set to other indoor units.)
NOTE
Depending on a model of the indoor unit, the deadband
is set on the indoor unit side. In this case, the deadband
setting is not displayed on this unit. If you want to change
the setting, consult an authorized service personnel.
(a) (b)
(c)
(a) Backward button
Tap to return to the previous screen.
(b) Home button
Tap to move to the temperature setting screen (home
screen).
(c) Setting buttons
Adjust the deadband range.
5-2-5 Set Temp. Limit
Power consumption by excessive temperature setting is sup-
pressed by restricting the temperature setting range for each
operation mode of Auto, Cool/Dry, or Heat.
5-2-5-1
(a)
(a) Toggle button
Tap to toggle enable/disable.
Enable
Disable
5-2-5-1 Set Temp. Limit (settings menu)
(a) (b)
5-2-5-2
(a) Backward button
Tap to return to the previous screen.
(b) Home button
Tap to move to the temperature setting screen (home
screen).
5-2-5-2 Limit of Cool/Dry or Heat
NOTE
The setting method for Cool/Dry and Heat is the same.
■
Example of the Limit of Cool/Dry screen
(1) Set the upper and
lower temperature
limits.
(2) Tap [OK] to return to
the previous screen.
En-23