Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
9
Section II. Unboxing Your Muse
Your Muse will require careful unboxing and examination of parts. You will need two able-bodied adults to
lift and place the machine.
Unboxing Steps
Follow these instructions for best results:
1. Prepare Work Space: You will need an open, level work space to place your laser cutter. A solid table
with adequate room for the machine is recommended (the machine’s dimensions are 32” x 20” x 8.75”). Be
sure the table is free of clutter and can support a minimum of 100 lbs. (the machine weighs 70 lbs. on its own).
2. Place Box: Set the box on a at space near where you will place the machine (such as the oor).
Open the box carefully from the top. If you use a cutting tool to open the box, be careful not to allow the
cutting edge to cut past the cardboard box. Always use all tools with caution and only as specied by the
manufacturer.
3. Remove Packaging: Gently remove the following from the box: the honeycomb table, the Quick Start
Guide and the top (4) foam pieces securing the machine.
4. Remove Accessories: Nestled in packing foam, inside the interior of the machine, are the following
parts and accessories: a plastic bag with cords and small accessories, and the coolbox. Inspect these
parts to ensure they are accounted for and intact.
5. Place Muse 3D: This will require two adults as the machine weighs approximately 70 lbs.Standing on
both ends, grip the machine from the bottom and gently lift the machine out of the box,leaving the bottom
foam still inside the box. Place on the clean, at table you plan on keeping it. Your Muse 3D is now unboxed.
6. Inspect your Muse 3D: If have any questions, contact your sales representative or customersupport.
Refer to your Muse 3D Quick Start Guide or download the Muse 3D User Manual for assembly instructions.
Fragile Parts! Be gentle in removing the foam packaging and accessories. Never
pull or force the packaging loose from the laser cutter. Be particularly aware that
the water inlet and outlet nodes protrude from the tube and are extremely fragile
when unboxing your laser tube
CAUTION
Note that if you purchased a Coolbox with your Muse 3D, you will be directed to
Appendix A: Coolbox Assembly for unpacking instructions
NOTICE
To Next Page
Loading...