Full Spectrum Laser MUSE 3D - Safety Override Waterflow Failsafe

Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
38
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
42
Safety Override Waterflow Failsafe
The laser will not fire unless water is flowing through the laser tube. The following
indicator informs
Muse 3D operators if water is not flowing.
Figure 5.4 Figure 5.5
If your touch screen indicates water is not flowing through the laser tube, check your water tube
connections and make sure your tubes and water chiller are assembled correctly. More than likely,
you have the water tubes reversed.
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
42
Safety Override Waterflow Failsafe
The laser will not fire unless water is flowing through the laser tube. The following
indicator informs
Muse 3D operators if water is not flowing.
Figure 5.4 Figure 5.5
If your touch screen indicates water is not flowing through the laser tube, check your water tube
connections and make sure your tubes and water chiller are assembled correctly. More than likely,
you have the water tubes reversed.
Section V. Touch Screen Interface
Safety Override Waterow Failsafe
The laser will not re unless water is owing through the laser tube. The following indicator informs Muse 3D
operators if water is not owing.
If your touch screen indicates water is not owing through the laser tube, check your water tube connections
and make sure your tubes and water chiller are assembled correctly. More than likely, you have the water
tubes reversed.