Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
24
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Alignment Test
The laser tube that came pre-installed in your Muse 3D was carefully aligned in our facilities in
Nevada. When you first turn on your machine, the mirror alignment should be perfect. It is possible,
however, that sometimes mirrors may come out alignment during shipping. Before running your first
job, you will want to check and make sure the mirrors are properly aligned using this simple test.
Once the mirror alignment is confirmed, you are ready to use your laser cutter. If your mirrors are out
of alignment, or if you have installed a new laser tube, you must align the laser using the procedure
provided. For this alignment test we will test fire the laser once in each corner of the machine to
make sure the laser is following the right path to the focus head, and ultimately to the cutting
material.
1. Open the Safety Lid: You will need to access the interior of the machine.
2. Place Thermal Paper: Take a small piece of thermal paper (approx. 15 mm should be plenty)
and place it over the focus lens under Mirror #3.
3. Position Laser Head: Move the laser head into the upper left corner of the workspace.
Figure 4.1 Figure 4.2
Mirror #3
Thermal Paper
Focus Lens
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Alignment Test
The laser tube that came pre-installed in your Muse 3D was carefully aligned in our facilities in
Nevada. When you first turn on your machine, the mirror alignment should be perfect. It is possible,
however, that sometimes mirrors may come out alignment during shipping. Before running your first
job, you will want to check and make sure the mirrors are properly aligned using this simple test.
Once the mirror alignment is confirmed, you are ready to use your laser cutter. If your mirrors are out
of alignment, or if you have installed a new laser tube, you must align the laser using the procedure
provided. For this alignment test we will test fire the laser once in each corner of the machine to
make sure the laser is following the right path to the focus head, and ultimately to the cutting
material.
1. Open the Safety Lid: You will need to access the interior of the machine.
2. Place Thermal Paper: Take a small piece of thermal paper (approx. 15 mm should be plenty)
and place it over the focus lens under Mirror #3.
3. Position Laser Head: Move the laser head into the upper left corner of the workspace.
Figure 4.1 Figure 4.2
Mirror #3
Thermal Paper
Focus Lens
Section IV. Tests & Adjustments
1. Alignment Test
The laser tube that came pre-installed in your Muse 3D was carefully aligned in our facilities in Nevada.
When you rst turn on your machine, the mirror alignment should be perfect. It is possible, however,
that sometimes mirrors may come out alignment during shipping. Before running your rst job, you will
want to check and make sure the mirrors are properly aligned using this simple test. Once the mirror
alignment is conrmed, you are ready to use your laser cutter. If your mirrors are out of alignment, or
if you have installed a new laser tube, you must align the laser using the procedure provided. For this
alignment test we will test re the laser once in each corner of the machine to make sure the laser is
following the right path to the focus head, and ultimately to the cutting material.
1. Open the Safety Lid: You will need to access the interior of the machine.
2. Place Thermal Paper: Take a small piece of thermal paper (approx. 15 mm should be plenty)and
place it over the focus lens under Mirror #3.
3. Position Laser Head: Move the laser head into the upper left corner of the workspace.
Before you start your rst job, it is important that your laser is tested in case it needs to be adjusted. Follow the
following steps to test and adjust your laser:
1. Alignment Test 2. Mirror Alignment Procedure
To Next Page
Loading...