Full Spectrum Laser MUSE 3D - Safety Override Lid Failsafe

Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
37
Section V. Touch Screen Interface
Safety Override Lid Failsafe
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
41
Safety Override Lid Failsafe
As a safety feature, the lid has a magnetic failsafe that disconnects the laser when the lid is
open.
this will be indicated by your touch screen display like so.
Figure 5.2
Figure 5.3
Be sure your lid is closed when you try to fire the laser. If the lid is closed and the laser still does not
fire, check that the lid magnet is touching the proper base magnet and that wires are connected.
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
41
Safety Override Lid Failsafe
As a safety feature, the lid has a magnetic failsafe that disconnects the laser when the lid is
open.
this will be indicated by your touch screen display like so.
Figure 5.2
Figure 5.3
Be sure your lid is closed when you try to fire the laser. If the lid is closed and the laser still does not
fire, check that the lid magnet is touching the proper base magnet and that wires are connected.
As a safety feature, the lid has a magnetic failsafe that disconnects the laser when the lid is open. this will be
indicated by your touch screen display like so.
Be sure your lid is closed when you try to re the laser. If the lid is closed and the laser still does not re, check
that the lid magnet is touching the proper base magnet and that wires are connected.