Need help?Do you have a question about the Full Spectrum Laser MUSE 3D and is the answer not in the manual?
General| Brand | Full Spectrum Laser |
|---|---|
| Model | MUSE 3D |
| Category | Measuring Instruments |
| Language | English |
Follow all safety protocols and procedures before operating any machinery.
Follow these safety guidelines at all times for safe operation.
Laser cutting systems can present a significant fire hazard.
Information on electrical safety and relevant standards.
Follow these instructions for best results when unboxing.
Lists all parts and accessories included with your laser.
Outlines the steps for preparing the laser cutter for use.
Remove zip ties securing the laser head and x-gantry.
Connect the exhaust fan and ducting to remove smoke and fumes.
Set up the water-cooled system for the laser tube.
Connect the air assist for cutting and engraving operations.
Connect the power cord to the laser system.
Connect the laser to a computer or router for software control.
Link the Muse 3D to RetinaEngrave v3.0 software.
Test laser mirror alignment using thermal paper.
Detailed steps for aligning laser mirrors.
Information on focus lens and camera maintenance.
Lid has a magnetic failsafe that disconnects the laser when open.
Laser will not fire unless water is flowing through the laser tube.
Accesses and manages previous job history.
Accesses device information, factory reset, and calibration.
Configure network settings for the laser.
Shows the status of the gantry lock for movement.
Core navigation and access to software features.
Set parameters for vector cuts and engravings.
Adjust raster settings like DPI, power, and speed.
Process of creating surface images on material.
Process of cutting lines or shapes based on vector data.
Guidance on testing materials for laser cutting.
Step-by-step guide to complete a project from concept to finish.
Use built-in tools for custom design creation.
Move the laser head manually or via software controls.
Methods to immediately stop laser operation.
Maintain and calibrate the camera for accurate positioning.
Step-by-step guide to replace the laser tube.
Instructions for installing or replacing drive belts.
Procedures for cleaning and replacing focus lenses.
Routine maintenance tasks for the laser system.
Instructions for unboxing the Coolbox accessory.
Detailed steps for installing the Coolbox.
Steps to install the rotary attachment accessory.
How to align the rotary attachment with the laser head.
Details on the standard 2.5" focus lens.
Information on the 2" focus lens for finer engraving.
Information on the 1.5" focus lens for extra fine engraving.
Information on the 5" focus lens for thick materials.
Contact information for support and sales teams.
Lists available accessories and consumables.
To Next Page