Full Spectrum Laser MUSE 3D - Connect Electrical Power

Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
21
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
24
Assembly Stage 5: Connect Electrical Power
Muse’s Laser System, and available accessories, are configured to accept 110VAC at 60Hz.
220VAC
units connect to power through an included converter (single-phase 220VAC).
1. Prepare Power Cord: Remove the electrical cord from its packaging.
2. Plug in Power Cord To Laser Cutter: The power cord plugs into a “C14” power receptacle
located on the right side of the machine.
3. Plug in Power Cord to Outlet: Plug the power cord into any proper outlet socket
in your workspace.
Figure 3.16
PRO TIP! Please be aware that the accessories will increase the circuit
load; the most significant power draw usually comes from the blower/
exhaust system. Consult the manufacturer’s information and manual for
the operating parameters of your exhaust system.
IN CASE OF A BLOWN FUSE: The laser system is equipped with
a fuse on the power inlet to protect the machine from surges or short
circuits. If this fuse ever needs replacement, please contact Full
Spectrum Laser technical support.
Section III. Installation & Assembly
5. Connect Electical Power
Assembly Stage 2: Connect Electrical Power
Muse’s Laser System, and available accessories, are congured to accept 110VAC at 60Hz. 220VAC units
connect to power through an included converter (single-phase 220VAC).
1.Prepare Power Cord: Remove the electrical cord from its packaging.
2.Plug in Power Cord To Laser Cutter: The power cord plugs into a “C14” power receptacle located on the
right side of the machine.
3.Plug in Power Cord to Outlet: Plug the power cord into any proper outlet socket in your workspace.
• Please be aware that the accessories will increase the circuit load.
The most signicant power draw usually comes from the blower/ exhaust system.
Consult the manufacturer’s information and manual for the operating parameters of
your exhaust system.
• In case of blown fuse, the laser system is equipped with a fuse on the power
inlet to protect the machine from surges or short circuits. If this fuse ever
needs replacement, please contact Full Spectrum Laser technical support.
NOTICE