Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
20
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
3. Attach Air Hose to Laser Cutter: Insert the other end of the black air inlet hose into the “air
inlet” nozzle in the back of laser cutter via the barbed air connect fitting.
Figure 3.14
4. Connect to Power: Plug the air compressor into the upper power plug marked
“air compressor” on the back of your Muse 3D. Note that air compressor will only turn on when
the laser is firing.
Figure 3.15
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
3. Attach Air Hose to Laser Cutter: Insert the other end of the black air inlet hose into the “air
inlet” nozzle in the back of laser cutter via the barbed air connect fitting.
Figure 3.14
4. Connect to Power: Plug the air compressor into the upper power plug marked
“air compressor” on the back of your Muse 3D. Note that air compressor will only turn on when
the laser is firing.
Figure 3.15
3. Attach Air Hose to Laser Cutter: Insert the other end of the black air inlet hose into the “air inlet”
nozzle in the back of laser cutter via the barbed air connect tting.
4. Connect to Power: Plug the air compressor into the upper power plug marked “air compressor” on the
back of your Muse 3D. Note that air compressor will only turn on when the laser is ring.
To Next Page
Loading...