Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
15
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Assembly Stage 3: Assemble the Water System
Muse 3D uses a water-cooled continuous beam CO2 laser tube. The tube requires a flow of room
temperature water to regulate the temperature of the laser tube. Your purchase includes
a water pump for cooling the laser tube. For Coolbox users, skip this step and refer to Appendix
A: Coolbox Assembly. Coolbox users will not need a bucket.
Never Fire the Laser: Without a correctly connected and
powered water pump. Firing the laser without turning the pump
on or, worse, with no water in the system, will severely degrade
or destroy your laser tube and void your warranty.
1. Remove Capping On Water Inlet / Outlet: Remove the short silicone tubing, capping
the water inlet and outlet on the back of the machine.
NOTE: Not needed if
you have a coolbox
*Please see page 95
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Assembly Stage 3: Assemble the Water System
Muse 3D uses a water-cooled continuous beam CO2 laser tube. The tube requires a flow of room
temperature water to regulate the temperature of the laser tube. Your purchase includes
a water pump for cooling the laser tube. For Coolbox users, skip this step and refer to Appendix
A: Coolbox Assembly. Coolbox users will not need a bucket.
Never Fire the Laser: Without a correctly connected and
powered water pump. Firing the laser without turning the pump
on or, worse, with no water in the system, will severely degrade
or destroy your laser tube and void your warranty.
1. Remove Capping On Water Inlet / Outlet: Remove the short silicone tubing, capping
the water inlet and outlet on the back of the machine.
NOTE: Not needed if
you have a coolbox
*Please see page 95
Section III. Installation & Assembly
3. Setup the Water System
Assembly Stage 3: Assemble the Water System
Muse 3D uses a water-cooled continuous beam CO2 laser tube. The tube requires a ow of room
temperature water to regulate the temperature of the laser tube. Your purchase includes a water pump for
cooling the laser tube. For Coolbox users, skip this step and refer to Appendix A: Coolbox Assembly.
Coolbox users will not need a bucket.
Never Fire the Laser without a correctly connected and powered water pump.
Firing the laser without turning the pump on or, worse, with no water in the system,
will severely degrade or destroy your laser tube and void your warranty
WARNING
1. Remove Capping On Water Inlet / Outlet: Remove the short silicone tubing, capping the water
inlet and outlet on the back of the machine.
To Next Page
Loading...