Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
16
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
2. Attach Water Pump Fitting: Remove the water pump from its packaging. Attach the
plastic fitting to the water pump by gently screwing it on.
Figure 3.7
3. Prep Water Bucket: Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled
water (not included). ALWAYS use only distilled water and replace often. It is recommended that you
choose a bucket with a lid and cut holes to allow the tubes to fit. This will prevent debris falling into
your water bucket.
Figure 3.8
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
2. Attach Water Pump Fitting: Remove the water pump from its packaging. Attach the
plastic fitting to the water pump by gently screwing it on.
Figure 3.7
3. Prep Water Bucket: Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled
water (not included). ALWAYS use only distilled water and replace often. It is recommended that you
choose a bucket with a lid and cut holes to allow the tubes to fit. This will prevent debris falling into
your water bucket.
Figure 3.8
2. Attach Water Pump Fitting: Remove the water pump from its packaging. Attach the plastic tting to
the water pump by gently screwing it on.
3. Prep Water Bucket: Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled water
(not included). Only use distilled water and replace often. It is recommended that you choose a bucket
with a lid and cut holes to allow the tubes to t. This will prevent debris falling into your water bucket.
To Next Page
Loading...