Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
17
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
4. Attach Inlet Water Tubing: Push one end of one of the two (2) silicone water tubes onto the
water pump fitting. Now attach the other end of that tubing to the “water inlet” located at the back of
machine. Completely submerge the assembled water pump in the bucket of distilled water.
Figure 3.9
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
4. Attach Inlet Water Tubing: Push one end of one of the two (2) silicone water tubes onto the
water pump fitting. Now attach the other end of that tubing to the “water inlet” located at the back of
machine. Completely submerge the assembled water pump in the bucket of distilled water.
Figure 3.9
4. Attach Inlet Water Tubing: Push one end of one of the two (2) silicone water tubes onto the water pump
tting. Now attach the other end of that tubing to the “water inlet” located at the back ofmachine. Completely
submerge the assembled water pump in the bucket of distilled water.
To Next Page
Loading...