Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
30
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
7. Reposition the X-Gantry to “Close” Position: Now that we have a burn mark on our
thermal paper from a “far” firing of the laser, we want to fire the laser from the closest position. Move
the X-Gantry to the upper most position in the machine and test fire again.
Figure 4.9
8. Re-Position X-Gantry back to “Far”: Jog or manually position the X-Gantry to the far
position where you did the first test fire. (as shown in Figure 4.7).
9. Check Results: There should be two observable burn marks on the thermal paper. If they overlap
perfectly you can move on to the next mirror. If they are apart, adjust the three 2.5mm hex screws on
Mirror #1 (not the red beam diode) to move the second burn mark over the red beam.
10. Repeat Until Aligned: Check your results by repeating this process until the two burn marks
are both center and perfectly overlapping each other. Once aligned, you will repeat this procedure on
the next mirror.
7. Reposition the X-Gantry to “Close” Position: Now that we have a burn mark on our thermal paper from a
“far” ring of the laser, we want to re the laser from the closest position. Move the X-Gantry to the upper most
position in the machine and test re again.
8. Re-Position X-Gantry back to “Far”: Jog or manually position the X-Gantry to the far position where you
did the rst test re. (as shown in Figure 4.7).
9. Check Results: There should be two observable burn marks on the thermal paper. If they overlapperfectly
you can move on to the next mirror. If they are apart, adjust the three 2.5mm hex screws onMirror #1 (not the
red beam diode) to move the second burn mark over the red beam.
10. Repeat Until Aligned: Check your results by repeating this process until the two burn marksare both
center and perfectly overlapping each other. Once aligned, you will repeat this procedure onthe next mirror.
To Next Page
Loading...