Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
65
Section VII. Operations
Project Workow
From Concept to Design
The RetinaEngrave v3.0 software works with your Muse 3D to create a simple and intuitive set of
operations that is easy to learn and use. With experience, you will nd your Muse 3D achieving amazing
results following this procedure. Use this Project Workow List for the “best practice” sequence for any
project and follow the step-by-step instructions from start to nish.
1. Create Design
Create your design in the
program of your choice.
Note: Files should be created
with laser cutting considered.
4. Place Material
Place your material into the laser
bed workspace.
3. Import Design
Create your design in the
program of your choice.
Note: Files should be created
with laser cutting considered.
2. Connect to Software
Link your Muse 3D to the software by
typing the IP address found on the Touch
Screen (Settings>Network>Copy IP) into
your browser (Google Chrome Suggested).
5. Align Laser
to Material
Using either the perimeter tool,
or camera function (see camera
features), align your design on the
appropriate area of your material.
6. Adjust Object
Properties
Using the Properties Manager
Window, adjust your Vector or
Raster settings for your cut,
mark or engraving
7. Run Job
Double check your safety
precautions and accessories,
and press the “play” button to
start the job.
To Next Page
Loading...