Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
85
5. Close the lid: Close the lid of the machine.
6. Verify no jobs: Ensure that there are no jobs actively on your machine or remove the water supply from
the machine so that the machine will not cut the calibration sheet. If the calibration sheet is damaged, the
recalibration process may not be effective.
7. Enter tools tab: Touch the Tools tab on the LCD screen of your machine.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and select Stitch
Calibration. This process should take about 5 minutes.
7. Enter tools tab: Touch the Tools tab on the LCD screen of your machine.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and select
Stitch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and use
the data to calibrate the camera to the work space. Avoid opening the lid during the calibration
process. This process should take about 5 minutes.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and
select Stitch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and
use the data to calibrate the camera to the work space. Avoid opening the lid during the calibration
process. This process should take about 5 minutes.
Section VII. Operations
Camera Calibration
7. Enter tools tab: Touch the Tools tab on the LCD screen of your machine.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and select
Stitch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and use
the data to calibrate the camera to the work space. Avoid opening the lid during the calibration
process. This process should take about 5 minutes.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and
select Stitch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and
use the data to calibrate the camera to the work space. Avoid opening the lid during the calibration
process. This process should take about 5 minutes.
6
7
8
The camera will take multiple images of the calibration sheet and use the data to calibrate
the camera to the work space. Avoid opening the lid during the calibration process.
NOTICE
To Next Page
Loading...