Need help?Do you have a question about the FUNcube Dongle Pro and is the answer not in the manual?
General| Type | Software Defined Radio (SDR) Receiver |
|---|---|
| Sampling Rate | Up to 96 kHz |
| Demodulation Modes | AM, FM, SSB, CW |
| ADC Resolution | 12-bit |
| Interface | USB 2.0 |
| Power Supply | USB powered |
| Input | RF input via SMA connector |
| Operating System Compatibility | Windows, Linux, macOS |
| Frequency Range | 150 kHz to 240 MHz (with gaps) |
| Frequency Ranges | 150kHz - 240MHz |
Plug the FUNcube Dongle into a USB port. HID drivers are usually shipped with Windows XP and higher.
Reduce the Dongle's output level to prevent overloading the console, as it appears as a soundcard.
Reduces spurs caused by DC offset. Select 'Spur reduction' from Options and start analysis.
Addresses image problems in soundcard SDR solutions. Use 'Image Rejection' from the Options dropdown.
Install the SDR-RADIO.com console software. The process is a standard Windows installation kit.
Guides through starting the soundcard and connecting the dongle via HID driver for frequency and options.
To Next Page