Funkwerk bintec WI-Client - Illustration 2 Connections and Leds

The ethernet port has a RJ45 plug. Because of the auto MDI functionality the WI-Client can be attached to a
HUB or the LAN port of a computer with standard patch cables. The WI-Client recognizes the cable polarity
and automatically connects the right signal lines.
The serial port is a 9 pin female D-SUB connector. The pinout makes it possible to connect to a computer
COM port with a 1 to 1 serial cable, the exact pinout is shown in Illustration above.
The power supply should be 9 – 35VDC / 3W. At 12VDC the input current is typical 250mA.
Back and front view:
LINK
100MBit
54321
9876
W
L
A
N
L
A
N
S
e
r
1
S
e
r
2
R
e
s
e
t
O
n
0V
NC
+ VB
RP-SMA antenna connector
Option for a 2. antenna connector
PIN Function Dir.
1 DCD IN
2TxDOUT
3RxDIN
4DSRIN
5GND
6DTROUT
7CTSIN
8RTSOUT
9RIIN
Illustration 2 Connections and LEDs
LED Function
On Green always on when power is on
WLAN Red blinking searching for RF-connection (scanning)
Steady green found a suitable Access-Point and established
a connection
Green blinking 802.1x Authentification is in process
Green + red blinking
RF activity (receive or transmit)
LAN Off no link is recognized
Green link is established with another LAN device.
Green + red blinking
activity on the LAN interface
Ser1 (2) Off interface is inactive or not connected to the
other (W)LAN-.communication side
Green connected to other serial device.
Green + red blinking
activity on the serial interface (receive or
transmit)
WI-Client Manual Version 2.16 V3 4