Furuno 821 - Outputting Cursor Position to Navigator; Displaying Cursor Position, Range and Bearing to Cursor; Visual Alarm Indications

20
2.30 Outputting Cursor
Position to Navigator
Cursor position (NMEA0183 data sentence
TLL) can be output to the navigator con-
nected to this radar by pressing and holding
down the [HM OFF] key.
2.31 Displaying Cursor
Position, Range and Bearing to
Cursor
The cursor data indication at the bottom of
the display can show cursor position in lati-
tude and longitude or the range and bearing
from own ship to the cursor. You can select
the indication desired by pressing the [HM
OFF] key.
2.32 Visual Alarm Indications
This radar display various visual alarms to
alert you to error.
Table 2-1 Visual alarm indications
The heading signal visual alarm may be
cleared by pressing the [DISP MODE] key.
rorrEmralalausiV
eslupgnidaehoNGNISSIMGISDH
eslupgniraeboNGNISSIMGISPB
langisgnidaeH
ffodenrut
sraeppa(*.***
)gnidaehsa