22
4. SETTING AND ADJUSTMENT
After installing the equipment, set up the own ship’s static information (MMSI, IMO
number, ship’s name, call sign, type of ship and GPS antenna position). Also, set
up the system settings, and measure the output power and frequency.
4.1 Setting MMSI and IMO Number
1. While holding down the [0] key, press the [POWER] key.
2. After the following message appears, release the [0] key. (It takes several
seconds before the message appears.)
NOWSTARTING
CHECKINGMEMORY
3. After the following window appears, enter the password. Note that the password
is known by only the FURUNO dealer.
[ENTER PASSWORD]
PASSWORD:
4. Press the [ENT] key to display the SET MMSI & IMO# window.
[SET MMSI & IMO#]
MMSI x x x x x x x x x
IMO# x x x x x x x x x
SET: [ENT]
Asterisk marks
current selection.
5. Enter ship’s MMSI (Maritime Mobile Service Identity) in nine digits.
6. Press the [NEXT] key to select IMO#.
7. Enter ship’s IMO number in nine digits. If the IMO number has 7 digits, enter “0”
twice followed by IMO#. IF the ship has no IMO number, enter all zeroes.
8. Press the [ENT] key to register data.
To Next Page
Loading...
