23
4.2 Setting Ship Name and Call Sign
1. Press the [MENU] key to open the main menu.
[MENU]
1 TARGET DATA
2 PLOTTER
3 OWN DATA
4 SET MSG
5 INIT SETTINGS
6 SYSTEM SETTINGS
7 DIAGNOSTICS
Main menu
3. Press the [5] key to open the INIT SETTINGS sub-menu.
[INIT SETTINGS]
1 SET SHIP DATA
2 SET DESTINATION
3 SET NAV STATUS
4 SET TYPE&CREW
5 SET CPA/TCPA
6 SET ANTENNA POS
INIT SETTINGS sub-menu
4. Press the [1] key to display the SET SHIP DATA window.
[SET SHIP DATA]
NAME:
C. SIGN:
DRUGHT: 08.0 m
DTE: KEY & DISP + /-
123
Input mode
123: Numeric mode
ABC: Alphabet mode
To switch between them, press the [SFT] key.
Do not change from KEY & DISP
SET SHIP DATA window
5. Enter ship’s name, using up to 20 alphanumeric characters. To switch between
alphabet and numerical character, press the [SFT] key. To enter an alphabet,
press corresponding key several times until desired letter is displayed. For
example, if you press the [2] key continuously, the character A, B and C appear
cyclically. If you want to enter the same letter or an other letter with the same
key (for example, AA or AC), press the [6] key while pressing the [SFT] key, to
send the cursor to the next position.
To Next Page
Loading...
