Furuno FAR-2338-NXT - 3. ADJUSTMENTS

3-1
3. ADJUSTMENTS
Note: After completing the settings and adjustments, copy the setting data to a SD-
card (SD card slot is in front of the processor unit), referring to the Operator's Manual.
This will allow easy restoration of setting data after the MAIN Board is replaced, etc.
At the first start-up after installation, turn on
the processor unit with the main switch. Open
the protected menus to adjust the radar. Fol-
low the procedures in this chapter to complete
the adjustment.
Below are the controls on the control unit
RCU-014/015(or optional RCU-016) that are
used to make the adjustments.
RCU-014
RCU-015/016
MAIN SW
Main switch
BRILL
EBL
F1
F3
F2
F4
OFF ON
RANGE
-
A/C RAIN A/C SEA
+
OFF
GAIN
ON
VRM
ACK
ALARM STBY
TX
TRAILS
CANCEL
TIME
VECTOR
7
CENTER
OFF
4
OFF
HL
1
BRILL
0
MODE
8
VECTOR
CU/TM
RESET
5
OFFSET
EBL
2
MODE
3
INDEX
LINE
6
LIST
TARGET
9
MARK
ENTER
CANCEL
TARGET
DATA
TARGET
ACQ
MENU
Power key
Mouse wheel
Track ball
MENU key
Left button Right button
HL OFF key
F4
F3
F2
F1
Mouse wheel
Track ball
Left button Right button
Power key
(RCU-015 only)
F1 key