Furuno FE-700 - Page 3

A1-1
Addenda No.1 to FE-700 service manual, Pub. No. SME-23660
How to upgrade software
Necessary tools:
1) A DOS/V compatible PC (NEC PC98 cannot be used.)
2) OS: MS-DOS/Windows 95/98
3) Interconnection cables: 80-0654 and SAP-161-101
4) New Software
Fabricate the interconnection cable between the monitor unit and the PC as below.
FE-700 PC
DATA Port MJ6P (D-SUB, 9 pins)
4 >- - - - - - - - - ->1>- - - - - - - - - <2
5 >- - - - - - - - - ->2> <1
6 >- - - - - - - - - ->3>- - - - - - - - - <3
7 >- - - - - - - - - ->4>- - - - - - <4
>5> <6
10 >- - - - - - - - - - >6>- - - - - - - - - <5
- - - - <7
- - - - <8
<9
Cable: SAP-161-101 Cable: 80-0654
1. New software supplied is a self-extracting file. Make a new file on the PC, copy a
file supplied, fe700vx.exe to the new file, then, double-click the fe700vx.exe icon.
Nine files are extracted.
Up700.bat, load600.b, load600.b96, uppg.exe, dummy.b, boot600.bin,
upboot60.bat, fe700t1.bin, update.txt
2. Copy these files to a floppy disk to execute the program from the floppy disk.
3. Connect the DATA port on the FE-700 display unit to the serial I/O port of the
PC.
4. Turn on the PC. Do not as yet turn on the FE-700.
5. Select MS-DOS prompt in the program file to run MS-DOS program.
C:¥windows> appears.
6. Insert the program disk and type A:, followed by Enter key.
A:¥> is on the screen.
7. Type up700 and press Enter key.