1. MOUNTING THE UNIT
4
10. Wrap self-bonding tape around the connection of antenna base and pipe, and then wind
vinyl tape over self-bonding tape.
11. Remount the antenna unit (upper) on the antenna base. (Torque: 2.6 N·m ± 10%)
12. Fix the ground wire RW-4747 (supplied) between the ground terminal on the antenna
unit and the ship’s ground point.
Cable tie
(weatherproofed)
Taping
(self-bonding
tape and vinyl
tape)
Ground terminal
Ship's ground point
Apply silicone rubber.
Mounting
13. Apply silicone rubber (supplied) to the ground terminal and three screws at the bottom of
antenna base.
14. Fix the antenna cable to the mast with a cable tie (local supply).
To Next Page
Loading...
