3. SETTINGS AFTER THE INSTALLATION
15
3.2 Setting the IMN (Inmarsat Mobile No.)
Set your IMN (Inmarsat Mobile No.) using the and PC as below.
1. Power on the communication unit and PC in order.
2. Double click [F16PC] on the screen to start the program.
3. Press the [F8] function key to show the Setup menu.
Setup
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm
1. System Setup
2. Editor Setup
3. Terminal Setup
4. EGC Setup
5. Auto Mode Setup
6. E-Mail Setup
7. Directories
8. Configuration
Setup menu
4. Press [1] key to display the System Setup menu.
Setup
9. Configuration
System Setup
01:53 02-02-25 (YY-MM-DD)
INMARSAT-C
INT
INT
INT
INT
System Date & Time
IMN
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
Network Setup
Command Window
System Setup menu
5. Confirm that the IMN is selected, and then press the [Enter] key.
The entering field appears.
6. Key in your IMN.
7. Press the [Enter] key.
8. Press the [Esc] key to escape from the entering field.
9. Press the [Enter] key.
To clear the IMN, press [I] [M] [N] in order while pressing the [Alt] key down at step 6.
When using the FELCOM 16 for VMS (Vessel Monitoring System), DNID (Data Network ID)
has to be downloaded via the LES (Land Earth Station). This arrangement is normally done
by authority of VMS.
To Next Page
Loading...
