1. MOUNTING THE UNIT
6
12. Fix the ground wire RW-4747 (supplied) between the ground terminal on the antenna
unit and the ground stud on the mast.
13. Connect the antenna cable (50 or 100 m) and cable assy (attached at step 4).
14. Wrap the connector with self-bonding tape and then vinyl tape. Bind the cable end with a
cable tie (local supply).
15. Fix the cable to the mast with cable tie (local supply).
Mast
Pipe
Taping
(Self-bonding
tape and vinyl
tape)
Cable tie
(Weatherproofed)
Ground terminal
See the figure in below.
Ship's ground point
Apply silicone rubber.
Mounting
Waterproofing
To Next Page
Loading...
