4.2 ID Setting
4-8
How to use INTERCOM
INTERCOM can be used between two Remote Handsets, and/or, between a Remote
Handset and Transceiver unit. While INTERCOM is being used caller’s Intercom
Naming: “OCCUPIED xxxxx” is displayed on other Handset, which is meant to
indicate that the intercom is in use.
To call up Remote Handset from Transceiver unit is as below. Same procedure is to be
taken when connecting between Remote Handsets, and/or, between a Remote Handset
and Transceiver unit. INTERCOM time out is 5 minutes. If the call is not picked up in 5
minutes (OFF HOOK), the call is automatically cancelled.
1. Press [SHIFT] -> [4:IntCom] key.
* Intercom Call Menu *
RT: FM-8800
1: Handset 1
2: Handset 2
3: Handset 3
4: Handset 4
2. Select Remote Handset to call up and press [ENT] key.
3. When a Handset is called up the beep goes off and the caller’s assigned ID will be
shown on the display of the Handset called up at the same time.
To cancel your call, press [CANCEL] key. Both Transceiver unit and Remote
Handset return to their normal display.
INTERCOM
FM-8800
4. INTERCOM communication is started.
Note:
You can adjust the volume by [MENU] -> VOLUME -> INTERCOM VOLUME. This
adjustment can be made with either Transceiver unit side or each Remote Handset side.
However, this function is currently inoperative. (2005/5)
“Intercom Naming” is displayed.
To Next Page
Loading...
