6.1 Adjustment
6-2
4. Select output to set up and press [ENT] key.
e.g. Select “HI” and press [ENT] key. Pop-up window will appear as below.
POWER Setup
HI PWR (0 – 255)
<■■■■ ＞ 127
EXT: ENT
5. Press PTT switch and adjust output power by turning Channel Knob while checking
output power.
6. Press [ENT] key to store output setup power data.
7. Carry out the procedure from step 3 to adjust “LOW” and “TEPM REDUCE”.
8. Turn off the power.
NOTE:
The following figure shows for Power Data vs Output Power. (The following value
varies Transceiver unit.) Adjustments of “HI”, “LOW” and “TEMP. REDUCE” are the
same curve and they can be adjusted respectively.
Fig. 6.1.2 Power Data vs. Output Power
0
0
20 40 60 80 100 120 140 160 180 200 220 240 255
10
20
30
40
5
15
25
35
45 W
FM-8800D
FM-8800S
Power
Power data
14Ｗ
25Ｗ
1Ｗ
Reference only
Default setting of Power data
(Russian Ver, ,and
INTL Ver. 03.01 and after)
- HI: 170
- LOW: 44
- TEMP. REDUCE: 134
To Next Page
Loading...
