8.2 DSC Communication Test
8-7
4. When receiving ACK BQ from No.2 VHF “ABLE ACKNOWLEDGE CALL
RECEIVED” will appear and alarm will go off. If you press [CANCEL] key, a
display will switch to VHF display and CH6 will be automatically set up.
5. With No.2 VHF, when receiving a call-up from No.1 VHF, ACK BQ will
immediately transmitted and alarm LED will blink and alarm will go off for 5
seconds. “ABLE ACKNOWLEDGE CALL IN PROGRESS” will appear on the
display.
6. Press [CANCEL] key, alarm will stop and transmitted message will appear.
7. Press [CANCEL] key a display will switch to VHF display and CH6 will
automatically be set up.
8. You carry out voice communication by CH6 between No.1 VHF and No.2 VHF.
9. The same procedure is taken to carry out a DSC test from No.2 VHF to No.1 VHF.
To Next Page
Loading...
