8.6 Remote Handset Test
8-24
Step-7) RB DIST LED
To end EEPROM test, press[▼]. Then, RB DIST LED test display will be shown as
below and pressing [▼] again will pop up RB SP test. Each test will continue until
another test begins.
RB DIST LED
LED on RB-8800 [DISTRESS] button will continuously blink every second.
RB SP
Speaker output of RB-8800 will automatically and continuously ON/OFF. The
volume can be adjusted with “VOLUME” on RB-8800
Step-8) Going back to Step-1
To end RB SP test, press [▼] continuously. This will bring you back to Step-1, LCD
brilliance test.
Step-9) Ending the test
To end the handset test, turn off the power and unplug the Remote Handset.
RB DIST LED RB SP
[ ]
To Next Page
Loading...
