To Next PageTo Next PageHow to show zero line on Furuno Plotter?
If the picture appears on your Furuno Plotter but the zero line is missing: The picture might be shifted, so check the shift setting. Also, verify if [ZERO LINE REJECTION] in the [FISH FINDER] menu is turned off.
How to improve picture sensitivity on Furuno Plotter?
If the picture sensitivity is too low on your Furuno Plotter: Check the gain setting in manual operation. Inspect the transducer for marine life or air bubbles. Consider that the bottom might be too soft to return an acceptable echo.
How to fix Furuno Marine GPS System when it will not turn on?
If your Furuno Marine GPS System won't power on, try the following: * Check for a blown fuse. * Ensure the power connector is securely fastened. * Inspect the power cable connector for corrosion. * Look for any damage to the power cable. * Verify the battery voltage is within the range of 10.8 to 31.2 V.
What to do if no picture appears on Furuno Marine GPS System, but the power is on?
If your Furuno Marine GPS System is powered on but the screen is blank, press the POWER/BRILL key and rotate the RotoKey clockwise to increase the screen brightness.
Why Furuno Marine GPS System position is not fixed within 90 seconds?
If your Furuno Marine GPS System fails to fix its position within 90 seconds, consider these steps: * Ensure the antenna connector is tightly secured. * Check the GPS Status Display for the number of satellites being received. * Verify that [POSITION&SOG/COG] in the [SELECT INPUT DEVICE] menu within the [INTERFACE] menu is set to [Internal GPS]. * Execute [RESTART GPS] located in the [INTERNAL GPS SETUP] menu under the [SYSTEM] menu.
What to do if Furuno Marine GPS System keys are not responding?
If your Furuno Marine GPS System is not responding to key presses, try turning the power off and then on again. If the issue persists, the key may be damaged.
General
