Need help?Do you have a question about the Furuno DUAL GPS GP-150-DUAL and is the answer not in the manual?
Lists the key functionalities and capabilities of the GP-150-DUAL system.
Explains the functions of each button and key on the control panel.
Details the procedure for powering the unit on and off.
Details how to register specific locations as waypoints.
Explains how to modify existing waypoint data.
Describes how to create a sequence of waypoints to form a route.
Details four methods for setting a destination point.
Explains how to calculate distances and bearings.
Introduces the system's aural and visual alarm capabilities.
Details setting arrival and anchor watch alarms.
Explains how to set XTE alarms for course deviations.
Guides on setting alarms for low, high, or within-range ship speed.
Details settings related to GPS fix mode, satellite, and smoothing.
Describes how to configure data output to external equipment.
Explains configuration for WAAS or DGPS beacon receiver.
Describes common error messages and their meanings.
Offers procedures to restore normal operation when issues occur.
Guides on performing memory, I/O, and keyboard tests.
Details mounting methods for the display unit.
Explains mounting instructions for the GPS antenna unit.
Illustrates cable connections to the rear of the display unit.
Guides on initial configuration after installation.
Provides specifications and installation details for the interface unit.
To Next Page
General
