To Next PageTo Next Page
Need help?Do you have a question about the Furuno NAVNET 3D MFD8/12/BB and is the answer not in the manual?
General| Chart Plotting | Yes |
|---|---|
| Radar Integration | Yes |
| Sonar Integration | Yes |
| Display Type | LCD |
| Chart Compatibility | Navionics |
| Radar Compatibility | Furuno DRS and FAR series |
| Sonar Compatibility | Furuno FCV and CH series |
| Networking | Ethernet |
| Display Size | 8" or 12" |
| GPS Receiver | Built-in |
Guidelines for selecting a location and mounting the MFD8/12 display unit.
Instructions for mounting the MFDBB processor unit on deck, desktop, or bulkhead.
Procedures for flush mounting the BlackBox keyboard (MCU-001) in a console or panel.
Details on connecting power to the MFD8/12 and MFDBB units.
Information on NMEA0183 data ports, their descriptions, and capabilities.
Explanation of NMEA2000 ports, network, and compatibility with MFDs and DRS.
Guidelines for connecting DRS radar sensors to the NavNet3D network.
Introduction to the NavNet3D network system and its components.
Configuring master settings, power synchronization, and monitor options.
Setting up NMEA2000 output data PGNs for MFDs in the network.
Configuring NMEA0183 input/output ports for individual MFDs.
Selecting primary data sources for various data types in the NavNet 3D network.
Setting up DRS radar sources, antenna height, and performing adjustments.
Explanation of the NavNet 3D SystemID and its purpose for customer identification.
Information on using the registration card for system registration and updates.
Illustrative examples of common NavNet3D system setups and configurations.
Step-by-step guide to configure AXIS IP cameras for use with NavNet 3D.
