33
The MFDBB processor unit has an Internal Hub that is compatible with Power
Synchronization. DIP switches inside the processor unit can be turned ON or OFF to
enable/disable the Power Synchronization feature. The number on each DIP switch
corresponds to the port number.
Additionally, to allow the Power Synchronization to work, a setting in the NN3D MFD’s
Software “Installation Wizard” must be turned ON (see Chapter 3 for more information)
2.7. Video Inputs
NavNet3D can use regular analog video inputs (PAL or NTSC) that connect to the
MFDs directly or use IP Cameras that connect directly to the network HUB. IP Cameras
can be seen by all MFDs connected to the NN3D network unlike analog video that can
To Next Page
Loading...
