36
2.8. External Monitors
2.8.1. MFD8/12
A DVI monitor can be connected to the MFD8/12 to repeat the screen at a remote
location. The plug is DVI-D format and only a DVI monitor can be connected.
The MFD8 has a 640x480 (VGA) DVI-D output. The MFD12 has an 800x600 (SVGA)
DVI-D output.
Furuno offers the following DVI cable:
- 5 Meter DVI Cable (FUSA P/N= 000-149-054)
- 10 Meter DVI Cable (FUSA P/N= CBL-DVI-10M)
Please refer to 2.10.1Waterproof Connection when Waterproof is needed
2.8.2. MFDBB
The MFDBB has two DVI-I output ports (Matched Selectable Res from 800x600 up to
1280x1024). The DVI-I output of the MFDBB will “Autosense” the monitors and allow
either DVI monitors or VGA monitors to be plugged in using a “DVI-I-to-VGA adaptor.
Both monitors must be the same type and resolution (VGA or DVI) when using both
ports:
When two monitors are connected to the MFDBB, you can choose to configure the
monitors either in Clone Mode or in Extended Mode.
Note:
When two monitors are connected to the MFDBB processor unit, they need to be
capable of displaying the same resolution
To Next Page
Loading...
