10. OTHER FUNCTIONS
10-10
3. Select the desired access
point with the CursorPad
then push the ENT key. You
are asked if you are sure to
connect to the selected ac-
cess point; push the ENT
key to connect. If the ac-
cess point is encrypted, the
dialog box shown below ap-
pears. Push the ENT key
then use the RotoKey
TM
to
enter the password. Rotate
to select alphanumeric character; push to confirm. After entering the last charac-
ter, push the ENT key consecutively until the [Accept] button is selected and "Con-
necting..." appears in the [Status] column.
4. If the connection is successful, "Connected" replaces "Connecting..." and the
[WIreless Connection] box appears and shows the name of the access point.
Press the ESC/MENU key several times to close the menu.
WIRELESS CONNECTION SETUP
Security
Network Name Signal Status
*
1
*
2
*
2
: Encrypted (WPE, EAP, TKPI)
: Open
: Encryption not supported (EAP)
*
4
*
4
: -80 dB to -71 dB
: -70 dB to -61 dB
: -60 dB to -51 dB
: -40 dB to -30 dB
: -50 dB to -41 dB
: -90 dB to -81 dB
: -100 dB to -91 dB
: -100 dB to -91 dB
: -90 dB to -75 dB
: -76 dB to -60 dB
: -61 dB to -45 dB
: -46 dB to -30 dB
The background color
is green when the unit
operates as an ad hoc
connection.
Security
Signal level
*
1
Wireless LAN signal level
Ext Antenna
Others
Wireless Off
*
3
*
3
Wireless LAN status
Status shown after access point is
once connected.
Activated: Ad hoc connection in
use.
Connected: Currently used access
point.
Saved: In-range saved access point.
Saved, not in range: Out-of-range
saved access point.
GP-1870-EXXX-XXXX
FURUNO Electric Co., Ltd.
DRS4W000
34540-G-0271
FURUNO_FAR3000
Network Name
Authentication Method
Encryption Method
Password
FURUNO Electric
WPA2-PSK
AES
Accept
To Next Page
Loading...
