13. INSTALLATION
13-16
How to extend cable length (GPA-017S)
The standard cable is 10 m long. For extension, in case of the GPA-017S, an antenna
cable set of 30 m or 50 m is available. Extension cable cannot be used with the GPA-
017.
Fabricate the end of the antenna cable and attach the coaxial connector. See the pre-
ceding page.
Transducer
Connect the transducer cable to the XDR port.
Transducer and sensor
Use the optional conversion cable (02S4147) to connect the optional speed/tempera-
ture sensor and the transducer to the XDR port.
ANTENNA UNIT GPA-017S
1 m
Antenna cable
30 m or 50 m
1 m
Fabricate locally.
To display unit
: Connector
Conversion cable assy.
Connect to XDR port
at rear of display unit
MJ-A10SPF
MJ-A6SRMD MJ-A10SRMD
From
sensor
From
transducer
Tape connectors with
vulcanizing tape and
then vinyl tape to
waterproof them.
Bind tape ends with
cable ties to prevent
tape from unraveling.
To Next Page
Loading...
