1. OPERATIONAL OVERVIEW
1-17
How to select the data to display in a quarter screen, half screen navigation data
1. Display a home screen that has a quarter screen or a half
screen with navigation data.
2. Long press the HOME/CTRL key to select the data display to
change. The selected indication is circumscribed with a red
rectangle.
3. Choose [Select Data] from the RotoKey menu.
4. Rotate the RotoKey
TM
to select the indication to change then
push the RotoKey
TM
. The [Select Data] window shows the
data categories available.
5. Rotate the RotoKey
TM
to select a category then push the key.
The right figure shows the choices available with [Navigation].
6. Select desired data.
Engine indications
The following engine indications are available, in the quarter screen.
Engine instance number
The engine instance number appears on all engine-related indications.
• Engine boost pressure • Engine trim
• Engine coolant pressure • Fuel pressure
• Engine load • Fuel rate
• Engine oil pressure • Total engine hours
• Engine oil temperature • Transmission oil pressure
• Engine speed • Transmission temperature
• Engine temperature
DST
DST-E
BRG
Engine Instance No.
0: Single engine, or PORT engine with 2 or 3 engines
1: STARBOARD engine with 2 engines,
or CENTER engine with 3 engines
2: STARBOARD engine with 3 engines
Note: This is the standard numbering method,
Different methods can be applied.
E-SPD 2 RPM
To Next Page
Loading...
