Furuno NAVNET 1734C - Cancelling Route Navigation

3. PLOTTER OPERATION
3-48
To select waypoint switching method do the following:
1. Press the MENU key.
2. Press the PLOTTER SETUP soft key.
3. Use the Cursor pad to select WAYPOINT SWITCHING.
4. Press the EDIT soft key to show the waypoint switching window.
5. Use the Cursor pad to select appropriate waypoint switching method;
PERPENDICULAR, ARRVL ALM CRCL (default setting), or MANUAL.
6. Press the ENTER soft key.
7. Press the MENU key to close the menu.
3.10.5 Canceling route navigation
Through the menu
1. Press the MENU key to open the menu.
2. Press the WAYPOINTS/ROUTES soft key.
3. Press the LOG soft key.
4. Press the STOP soft key.
5. Push the ENTER knob.
6. Press the RELEASE soft key.
7. Push the ENTER knob.
On the plotter display
1. Use the Cursor pad to place the cursor on the waypoint selected as destination.
2. Press the CLEAR key.
The message “STOP GOTO?” appears.
3. Push the ENTER knob.