7. CUSTOMIZING YOUR UNIT
7-31
Displaying DECCA TDs
1. Select CHAIN, then press the EDIT soft key to show the chain & station pair window.
CHAIN STATION PAIR
S BALTIC
01 R-G
▲
▼
▼
Decca chain and station pair window
2. Adjust the Cursor pad
upward or downward to select Decca chain number.
3. Roll the Cursor pad rightward to show the display below, to enable selection of station
pair.
CHAIN STATION PAIR
S BALTIC
R-G01
▲
▼
▼
Decca chain and station pair window
4. Adjust the Cursor pad upward or downward
to select station pair (R: red, G: green and
P: purple).
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter position offset to refine Decca position. Select (CHAIN)
CORRECTION 1 or CORRECTION 2, then press the EDIT soft key. Enter correction
value with the Cursor pad and ENTER knob. Use the
+
< − −> - soft key to switch from plus to minus and vice versa. Press the ENTER soft key
or push the ENTER knob.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select “DECCA” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”
10. Press the MENU key twice to close the menu.
To Next Page
Loading...
